99 zx9r - Does this look right?

So I started stripping the bike down in May 2012. Long story short, it ended up at a mates place and I got it back in bits a few weeks ago.
I have a Haynes manual but it doesn't seem to help, so is everything in the picture in its correct place?

Attachments

IMG_20140822_120335.jpg (132.59 KiB) Viewed 6926 times

Nothing is standing out as completely out of place. As long as the airbox goes on without fouling I'd say ur good to go.

Looks ok from here, with the exception of the ram air tubes a little to far over the motor. I can PM you some pictures out of the Kawasaki manual if you think that may help?

Get rid of the KLEEN stuff.

Does getting rid of the Kleen stuff do much? Been thinking about that for my one? You mean buying the blanking plates for top of the rocker covers and removing the plumbing??

Doesn't add any hp but reduces the backfire and popping on decel and makes it easier to tune air fuel ratios.
You don't need block off plates, just put a connector or a hose between the outlets in the plates in there and block the hole in the air box..

Looks ok from here, with the exception of the ram air tubes a little to far over the motor. I can PM you some pictures out of the Kawasaki manual if you think that may help?

That'd be great thank you. I think I've got the tubes in backwards.
I'm off to bunnings to get some 16mm copper tubing to connect the kleen tunes together.

Also any idea where this house plugs into?
It connects at the back of the carburetors right I'm the middle

Attachments

IMG_20140825_122820.jpg (154.04 KiB) Viewed 6837 times

Back of the carbs?

might want to have a look, looks like the line from the Radiator to the back of the barrels

Isn't that the one that goes into air intakes in the front fairing.?
If so it pressurizes the float bowl

Looks like the line to the radiator.

goes to the radiator. Think that its the one that connects just below the radiator cap.

Carb heater hoses I think from my drug fucked memory.......

Ok next question. The thing in the photo. It's meant to go on the rear engine bolt above where the sprocket is. Does it serve a purpose? Because it's a caaaarnt to fit

Attachments

IMG_20140923_130314.jpg (158.18 KiB) Viewed 6576 times

Its a spacer, you dont want to be leaving that off