by QQQ » Tue Apr 30, 2013 8:34 am
I've used these on a number of bikes and they work well but....to get them to work well they have to be ground and have the buttons tweaked to loosen them off so the rotors float properly. The guys that run the business seem like good guys, provide a good service and they have a machinist that will do the grinding/adjustment at your expense....if you do decide to go with them I would strongly recommend you get them machined. (And don't use EBC HH pads with them either, the rotor material doesn't seem to like them which in my experience caused alot of overheating. Galfer or Ferodo work well.)