ZX2R, ZXR400, ZXR750, ZX6R, ZX7R, ZX9R & ZX12R & others.
Post a reply

Re: The lights are on but no start.

Thu Feb 10, 2011 3:41 pm

robracer wrote:Awesome Joe, so when we going for a ride? :P


If I can finish it on Saturday a ride to the pie might be on the cards

Re: The lights are on but no start.

Thu Feb 10, 2011 4:09 pm

mmm, on Kwakawidow's birthday occasion18.gif ..... I think not :x
The request for bedside service in the am will take its toll on a pie run :roll: :P
The following week could be better ;)

Re: The lights are on but no start.

Thu Feb 10, 2011 7:23 pm

The Pirate Returns :twisted:

Re: The lights are on but no start.

Fri Feb 11, 2011 7:41 am

robracer wrote: The following week could be better ;)


That could be better for me too as a few things have come up for Saturday so I don't know how much I will get done on the bike.

Re: The lights are on but no start.

Tue Feb 15, 2011 4:28 pm

Greenblood wrote:Spot on Rob, the switch was playing up.
A strip & clean & it's all good. :D :kuda:


Good to hear you got it sorted Joe and ended up being an easy fix. :kuda:

Re: The lights are on but no start.

Tue Feb 15, 2011 4:36 pm

It was an easy fix Kev......but two days later playing up again :?
I may have to get a replacment...

Re: The lights are on but no start.

Tue Feb 15, 2011 7:05 pm

Trip to the wreckers...... & wont cost much :)

Re: The lights are on but no start.

Wed Feb 16, 2011 7:04 am

It might be worth trying to bypass the kill switch to see if that solves the problem and make sure that's where the fault lies. You've gotta pull it apart to replace it anyway if that is the case or you can then just run it using the ignition, sounds bodgy I know but could be a temporary solution.

Re: The lights are on but no start.

Wed Feb 16, 2011 8:17 am

Kev wrote: You've gotta pull it apart to replace it anyway

Plug & play.... replace the whole switchblock ;)

Re: The lights are on but no start.

Wed Feb 16, 2011 8:21 am

robracer wrote:
Kev wrote: You've gotta pull it apart to replace it anyway

Plug & play.... replace the whole switchblock ;)


I think that's the best option

Re: The lights are on but no start.

Wed Feb 16, 2011 4:58 pm

Best idea mate..I had loads of trouble starting..you know ...clicking and farting. I had to replace the switch block because the start button flew off and, wa la.. no more starting worries. It fires up first go..Kelens had nine in stock.. :shock: $140.00 I think
Post a reply