Mon Apr 17, 2006 2:19 pm
Mon Apr 17, 2006 2:51 pm
Mon Apr 17, 2006 3:12 pm
Mon Apr 17, 2006 3:26 pm
GPX.Lainie wrote:Rant all ya like cause that really sucks what hey did![]()
Mon Apr 17, 2006 4:01 pm
Mon Apr 17, 2006 5:23 pm
fidler28 wrote:Stuff standing back i would of belted the s&*t out of them you dont touch other peoples property expecially there bike or car
Mon Apr 17, 2006 6:37 pm
Mon Apr 17, 2006 9:02 pm
Mon Apr 17, 2006 9:03 pm
Mon Apr 17, 2006 9:10 pm
Mon Apr 17, 2006 9:59 pm
Yeah man, me too.vinze wrote:big respect in restraining yourself bud, not sure if id of kept the same carmness
Mon Apr 17, 2006 10:05 pm
RG wrote:Yeah man, me too.vinze wrote:big respect in restraining yourself bud, not sure if id of kept the same carmness
I would have taken a piece out of them (like a piranha).
Mon Apr 17, 2006 11:18 pm
Neka79 wrote:assholes deserve a belting..as for rectifying the problem mate, its pretty simple...
wot bike is it ?? if its got a centre stand sit it on that, then get a volunteer to sit there ass on the pillion seat..hence lifting the front...
failing this (no centre stand) jack up the front using a jack or a front end stand...
loosen the top tripple tree just a little bit..not too much or the forks will fall right out...
loosen the lower triple clamp (see above) ..not too much, just enuf that u can "manipulate" the forks back into position...
the bolts should be abt a 12mm nut horizontal to the ground, going into the triple clamp ....
once uve re-aligned them just tighten them up..problem solvered!!
HTH
Mon Apr 17, 2006 11:26 pm
87Ninja wrote:Neka79 wrote:assholes deserve a belting..as for rectifying the problem mate, its pretty simple...
wot bike is it ?? if its got a centre stand sit it on that, then get a volunteer to sit there ass on the pillion seat..hence lifting the front...
failing this (no centre stand) jack up the front using a jack or a front end stand...
loosen the top tripple tree just a little bit..not too much or the forks will fall right out...
loosen the lower triple clamp (see above) ..not too much, just enuf that u can "manipulate" the forks back into position...
the bolts should be abt a 12mm nut horizontal to the ground, going into the triple clamp ....
once uve re-aligned them just tighten them up..problem solvered!!
HTH
Thanks for the helpand about restraining myself, if i was out of work hrs it would of been a different story
Tue Apr 18, 2006 12:39 am