Kawasaki Sportsbike Riders Club - Australia - Online Forum

Please help...
Gotta drill a hole in the belly pan of the bike about 20-25mm in size to meet GCR's...now l know how to drill the hole but you guys got any suggestions as to where l would get some blank grommets to fit the 20-25mm hole??
Any info is appreciated!!!

try your nearest boat and marine retailer. they should be using them to run wires in alloy boats.

If you mean a solid rubber blanking plug, just drop into your local Commodore wreckers and grab one of the rubber plugs that fit into holes in the boot - drainage plugs I think ? they are very close to 25mm across.

cheers
RubberBootButtPlugDave

Simmo_ZX9R wrote:Please help...
Gotta drill a hole in the belly pan of the bike about 20-25mm in size to meet GCR's...now l know how to drill the hole but you guys got any suggestions as to where l would get some blank grommets to fit the 20-25mm hole??
Any info is appreciated!!!

Mate go to purple pig in mcintyre rd sunshine. or rare spares in gilbert rd preston.

Simmo_ZX9R wrote:Please help...
Gotta drill a hole in the belly pan of the bike about 20-25mm in size to meet GCR's...now l know how to drill the hole but you guys got any suggestions as to where l would get some blank grommets to fit the 20-25mm hole??
Any info is appreciated!!!

Simmo
Repco (and autobarn i think)
sell lil' packs of grommets
from about 5mm up to 32mm
cost me $6 a few years for the pack with about 10 grommets
in it
take ya pick from 'blanking' grommets (no hole)
or wiring/harness ones (mit hole)


cheers

Goose one of your best heheheheheheheeee;
Cheers Brett

*takes a bow*

Take apart the glass bong and use that....

of course, you mean the rubber foot eh ????? but then you would have dirty billy water all over the place uurrgrgghhhh and we all know how bad that smells

you could try off ya tree ;P

Shit I guess I will have to do this too.....

I hate effort.

Simmo_ZX9R wrote:Please help...
Gotta drill a hole in the belly pan of the bike about 20-25mm in size to meet GCR's...now l know how to drill the hole but you guys got any suggestions as to where l would get some blank grommets to fit the 20-25mm hole??
Any info is appreciated!!!

If all else fails let me know your address and I will mail you the one I found in the shed this arvo...

...gotta love Melbourne Cup holidays

Couldn't give a stuff about the horse race though, I just like the day off. It's not a public holiday up here either, so the shops are open. Given I only get 3 hours on a Saturday to do all the local shopping this is a bonus.

Just threw a Valiant item in mine today. Works great!