rubber grommets

[Simmo_ZX9R]

Please help...
Gotta drill a hole in the belly pan of the bike about 20-25mm in size to meet GCR's...now l know how to drill the hole but you guys got any suggestions as to where l would get some blank grommets to fit the 20-25mm hole??
Any info is appreciated!!!

[bigtez]

try your nearest boat and marine retailer. they should be using them to run wires in alloy boats.

[Gosling1]

If you mean a solid rubber blanking plug, just drop into your local Commodore wreckers and grab one of the rubber plugs that fit into holes in the boot - drainage plugs I think ? they are very close to 25mm across.

cheers
RubberBootButtPlugDave

[Blue14]

Please help...
Gotta drill a hole in the belly pan of the bike about 20-25mm in size to meet GCR's...now l know how to drill the hole but you guys got any suggestions as to where l would get some blank grommets to fit the 20-25mm hole??
Any info is appreciated!!!

Mate go to purple pig in mcintyre rd sunshine. or rare spares in gilbert rd preston.

[Smitty]

Please help...
Gotta drill a hole in the belly pan of the bike about 20-25mm in size to meet GCR's...now l know how to drill the hole but you guys got any suggestions as to where l would get some blank grommets to fit the 20-25mm hole??
Any info is appreciated!!!

Simmo
Repco (and autobarn i think)
sell lil' packs of grommets
from about 5mm up to 32mm
cost me $6 a few years for the pack with about 10 grommets
in it
take ya pick from 'blanking' grommets (no hole)
or wiring/harness ones (mit hole)


cheers

[Nanna10r]

Goose one of your best heheheheheheheeee;
Cheers Brett

[Gosling1]

*takes a bow*

[zxsixr03]

Take apart the glass bong and use that....

[Gosling1]

of course, you mean the rubber foot eh ????? but then you would have dirty billy water all over the place uurrgrgghhhh and we all know how bad that smells

[smek]

you could try off ya tree ;P

[HemiDuty]

Shit I guess I will have to do this too.....

I hate effort.

[Ratmick]

Please help...
Gotta drill a hole in the belly pan of the bike about 20-25mm in size to meet GCR's...now l know how to drill the hole but you guys got any suggestions as to where l would get some blank grommets to fit the 20-25mm hole??
Any info is appreciated!!!

If all else fails let me know your address and I will mail you the one I found in the shed this arvo...

...gotta love Melbourne Cup holidays

Couldn't give a stuff about the horse race though, I just like the day off. It's not a public holiday up here either, so the shops are open. Given I only get 3 hours on a Saturday to do all the local shopping this is a bonus.

[HemiDuty]

Just threw a Valiant item in mine today. Works great!