Going racing again! another Bike Build

i think the terminology is 32, un-bridled, tyre frying, terrifying, horsepower.

That sounds very tidy.!!

Sounds pretty sweet Rob

great job on this build mate, bike looks sweet as

well done

Nice Rob

So much for possible ground clearance issues, could fit a bus under there

Attachments

_DSC2228.jpg (69.02 KiB) Viewed 7590 times

you have a lot of room to play with in terms of ride heights or dropping the forks through a bit

Heh what did they say to you about a bellypan/catchtank ?? No issues with your bike not having one ?

Zero Issues Gos, I have jacked up the rear end with longer shocks & had no problems with turn in so I will leave the forks as is, I was more concerned with the pipe clearance, the rearsets are real high which helps

cool OK thank mate, I was a bit worried about having to fit one to the 250/3

more worried about the brakes on the baby triple at the moment a test ride next week will be interesting

Brakes on the 350F are non existant, stainless disk is shite

was just about to ask that... 'cause the ones on the 500F are pretty scary too! Are you even allowed to run dual discs or something?

....Brakes on the 350F are non existant, stainless disk is shite.....

yeh those OEM period discs are shitful, and the calipers are pretty crook as well. You could change to an RD front end - awesome discs & calipers

but the drum brakes on the S1 ??? FMD I better make sure the rear brake is good, that is where all the braking will be done.....

I put twin discs on mine back in the day. The brakes were better, but I can say the pads lasted like for-evah...

(-&

Brakes on the 350F are non existant, stainless disk is shite

What calliper are you running on it?