Page 1 of 1

Some good vids for MOST practice

PostPosted: Thu Jul 16, 2009 12:07 pm
by waynemorgan
Found some handy vids for those riders looking towards their MOST test -





He's got several more that look pretty good.

:D

Re: Some good vids for MOST practice

PostPosted: Thu Jul 16, 2009 12:31 pm
by tim
good post wayne :kuda:

where's the one teaching wheelies? :twisted:

Re: Some good vids for MOST practice

PostPosted: Thu Jul 16, 2009 1:09 pm
by DMonkey
Sweet thanks! Im pretty sure i have been struggling with them a little cause i wasnt coutner balancing them properly!
I will be practacing them this weekend!

Re: Some good vids for MOST practice

PostPosted: Thu Jul 16, 2009 1:36 pm
by Glen
Good find

Be careful though, the measurements are wrong eg the US most uturn is 24ft, ours is 6m which is more like 2 car parking spots.

The techniques are all good though

While you're there have a look at the braking one and the getting started one. Plenty of good advice .

Re: Some good vids for MOST practice

PostPosted: Thu Jul 16, 2009 1:50 pm
by waynemorgan
Thanks Glen - I was going to mention that.

NSW MOST for U turn is 6.1m which is approx 20feet - so as Glen says 2 car parking spots.

I'm heading to a car park this weekend :D

Re: Some good vids for MOST practice

PostPosted: Thu Jul 16, 2009 6:54 pm
by kevindinho
DMonkey wrote:Sweet thanks! Im pretty sure i have been struggling with them a little cause i wasnt coutner balancing them properly!
I will be practacing them this weekend!



I found it hard on my ZXR doing the u-turn because the handle bars were so low so theres not enough space to control the throttle at full lock, i think its the same as ur ZZR. Have you done you P's test yet?

Re: Some good vids for MOST practice

PostPosted: Thu Jul 16, 2009 8:45 pm
by Dizzi
Awesome vids Wayne, got some good tips from them, thanks, man wish I hadn't had wine and it wasn't raining otherwise would have gone out to practice ah vell next week for sure.

Re: Some good vids for MOST practice

PostPosted: Fri Jul 17, 2009 1:59 am
by tim
"coney-baby, TALK TO ME!"