Front sprockets

[Awesome]

Hey guys I want to go to a 16 tooth front sprocket have all the gear but the nut is very tight. Just checkin is it left hand or right hand thread?

Cheers Rob Cairns

[Blurr]

you'll need a rattle gun or a big fark off breaker bar to get it off. They all come out of Kawa Japan like that.

Best bet if you dont have access to either, is go to a tyre shop and get them to take it off for you.


In either case make sure a single hex nut is used.

Oh and it is standard thread

[Phil]

Yep, what Russ said. If you go to a shop to get it done you can then just do it up a little (I shit you not) and bend the washer dodadthingy back over to go home and then take it off, thats what I have done on a few occasions. No need to tighten the fuck out of it when you do it up, either, that washer bent over will do that

[Awesome]

Thanks Guys

[Awesome]

Goes much better now

[Blurr]

Good to hear.

It is a must do mod for most modern roadies if you ask me.