Kawasaki Sportsbike Riders Club - Australia - Online Forum

Posted: **Thu Apr 26, 2007 5:23 pm**

Hi all,

My ZZR 250 was donw to 80 psi in the left cylinder. Turns out there is no clearnce between the rocker and trhe valve

Time to reset the clearences,

Its a 2001 ZZR 250. does anyone know what the correct valve clearences are ?

sorry if this has been asked before but nothing came up in seach.

thanks

Posted: **Thu Apr 26, 2007 5:50 pm**

from memory the intake should be 0.08mm (0.06-0.1 being the acceptable range) and exhaust 0.12mm (0.10 to 0.15mm)

Posted: **Fri Apr 27, 2007 9:32 pm**

Inlet 0.08~0.13mm
Exhaust 0.11~0.16mm

From the official Kwaka ZZR service manual

Posted: **Fri Apr 27, 2007 11:59 pm**

shoot, i wasnt totally right, but i was close

Posted: **Mon Apr 30, 2007 12:18 am**

You were that close from memory.

I wish my memory was that good, both of your solid stats were inside tolerence

. I'm a ZZR250 nut and I had to look it up. :oops:

Posted: **Mon Apr 30, 2007 7:29 am**

helps to have done clearances more than a handfull of times

Kawasaki Sportsbike Riders Club - Australia - Online Forum

valve clearences on ZZR250

valve clearences on ZZR250