Kawasaki Sportsbike Riders Club - Australia - Online Forum

http://www.motorcyclenews.com/nav?page= ... ODUCT-NEWS

For all you lucky buggers riding 05's.

the two bros looks the best IMO
Not that i can afford one at the mo

Would the twin exhaust suit the back of the 6R?

I'd have to have a closer look...

Sounds a bit heavy to me, I think it needs to go on a diet.

red_dave wrote:Would the twin exhaust suit the back of the 6R?

I'd have to have a closer look...

check out the two bros zorst here, pisses all over it...

http://www.twobros.com/cgi-bin/shopper? ... -VALE.html

Micron have a sensational looking pipe too

if i had the money id get the two bro's or akra for my 05. but i dont
i have to get a new rear tyre but

I think the Micron twin rocks, Maybe cause its what I'm getting

http://news.micronexhaust.com/newproducts.php/52

Akra ALL the way!
What about Arata, looks like an Akra & slightly cheaper!

The 2 bro's ya dont need a re-map as far as i know to gain the extra hp.

i saw a video clip of the two bro's, sounded hot

Akra for 05 636

Nick wrote:Akra for 05 636

One fenderectomy comming up....

I have ordered the Akra system because I think it looks like the only can that is made for our bike. The side entry pipe removes that wicked s-bend that the other manufacturers are using. From what I have heard it is going to give big gains without remapping. Plus it looks pretty good too.

samhasa636 wrote:I have ordered the Akra system because I think it looks like the only can that is made for our bike. The side entry pipe removes that wicked s-bend that the other manufacturers are using. From what I have heard it is going to give big gains without remapping. Plus it looks pretty good too.

Do you know how replacing the whole system effects the exhaust valve? (for low rpm running) I was advised with mine to only go the slip on as this valve is an important part of engine management system.