zx636r oil filter size

anyone knows???? as i'm buying or thinking to buy , will it fit???


http://cgi.ebay.com.au/OIL-FILTER-RATCH ... dZViewItem

well priced too????

That is the one i was trying to say in your other thread, it works great.

Yes it should fit, the claw opens up as you turn it so it works both directions.

The 636 has a retasining clip on the oil filter hidepenny make sure you take that off first and i fitted most of my oilfilters so i can get them off easy too but if i get a tough one I just punch a hole through it with a phillips head screwdriver and use that as a handlle, works a treat.

Just need to make sure you have plenty of rag underneath cause it pisses out everywhere I used that trick when i got the factory filter off

bob is right about the philips head trick! cheaper than buying the tool

i found mine came off easy ... just used my hand! just remember u dont have to do them up super duper tight, just screw it on .. then give it a nip sorta thing to secure it ..

just use k&n oil filters, they have a 19mm nut on top so all you ever need is a spanner (which i am sure you have somewhere)