Shortening DONE! (14 pipes)

Step one: find something suitable to mark your cut line. (old piece of tape measure)
Step two: Cut it. (used Dremel)
Step three: Slide the whole end off.
Step four: Discover there's a whole lot more inside than you expected!
Step five: Cut the bloody lot off
Step six:.......Forget to take pic's
Step seven: Remove end cap without damaging it (Difficult FFS!!!)
Step eight:....Forget again
Step nine:Reasemble...
Step two: Cut it. (used Dremel)
Step three: Slide the whole end off.
Step four: Discover there's a whole lot more inside than you expected!
Step five: Cut the bloody lot off
Step six:.......Forget to take pic's

Step seven: Remove end cap without damaging it (Difficult FFS!!!)
Step eight:....Forget again

Step nine:Reasemble...