Step one: find something suitable to mark your cut line. (old piece of tape measure)

- ZX14 Original Pipes (11).jpg (111.41 KiB) Viewed 10016 times
Step two: Cut it. (used Dremel)

- ZX14 Original Pipes (1).jpg (94.46 KiB) Viewed 10016 times
Step three: Slide the whole end off.

- ZX14 Original Pipes (3).jpg (125.77 KiB) Viewed 10016 times
Step four: Discover there's a whole lot more inside than you expected!

- ZX14 Original Pipes (4).jpg (83.6 KiB) Viewed 10016 times
Step five: Cut the bloody lot off

- 21052011257.jpg (132.63 KiB) Viewed 10016 times
Step six:.......Forget to take pic's
Step seven: Remove end cap without damaging it (Difficult FFS!!!)

- ZX14 Original Pipes (7).jpg (99.15 KiB) Viewed 10016 times
Step eight:....Forget again
Step nine:Reasemble...

- 22052011259.jpg (140.14 KiB) Viewed 10016 times