Pilot Power Race's - opinions

For general Technical and Performance Discussions

Pilot Power Race's - opinions

Postby swabio-ACT » Thu Feb 09, 2006 2:10 pm

Well,

I am considering getting some PPR's for my next set of tyres, prior to doing a trackday (hopefully Mar 18 @ EC) and was wondering what the opinions of those who HAVE ridden with them.

also what kind of distances are you getting out of them? Also what compound are you running?

Cheers
Image
User avatar
swabio-ACT
KSRC Contributor
KSRC Contributor
 
Posts: 1635
Joined: Sat Mar 26, 2005 9:52 pm
Location: Brisbane, Australia
Bike: ZRX
State: Queensland

Postby icebreaker » Thu Feb 09, 2006 2:43 pm

I ran a set for a track day and then a few weeks after till I killed the rear doing reefton, then just ran the pilot race on the front for a while till the bump on the nose, and to save insurance hastles I put the diablo back on.


I found them to be tops.. The front is abit iffy for the first say 1km, cause it's cold but after that they're nice, I had them over winter and rode in the wet, didn't have any problems up sydney road and with the tram lines.

The rear certainly doesn't last very long, so my tip would be to use them for a track day, and a good ride on a couple of weekends then pull them off and save them for the next track day.

I paid like $150 each, and I know you can get them for as little as $80ea with about 10-20 laps on them... or off them depending on how you look at it.
Ducati Monster S2R1000
Kawasaki '77 Z1000A1, '76 z900 (Project) & '78 Z1000A2 (Project)

http://www.unihost.com.au - Affordable, Reliable Webhostng
icebreaker
Administrator
Administrator
 
Posts: 2794
Joined: Wed Apr 07, 2004 7:07 pm
Location: Hobart
Bike: Z1000
State: Tasmania

Postby swabio-ACT » Thu Feb 09, 2006 2:52 pm

Dan wrote: I paid like $150 each, and I know you can get them for as little as $80ea with about 10-20 laps on them... or off them depending on how you look at it.


Dan,

thanks for the info, so did you get them 2nd hand? I know Chris Burke sells them 2nd hand. I am thinking about getting a 2nd hand set to give them a try first. or get them shipped down from Mick, as in cbr, they are pretty pricey, i recall getting quoted $380 R and $280 F....... (i think - I will get a quote again soon)

Although i was thinking, if I want to get them taken off after track days, I may as well just get slicks...... I Dunno, too much to think about! lol
Image
User avatar
swabio-ACT
KSRC Contributor
KSRC Contributor
 
Posts: 1635
Joined: Sat Mar 26, 2005 9:52 pm
Location: Brisbane, Australia
Bike: ZRX
State: Queensland

Postby Nanna10r » Thu Feb 09, 2006 7:30 pm

Only had a rear, it was fitted for the motogp trip from ACT to PI and back to ACT @ 2500kms & it was Toast when we got back to ACT. Thats on a fat slow ol 9 with a Nana riding it with 30kgs of Bags on the rack. I have DVD of some of the more interesting bits.
BESTEST Tyre i've used for Actual grip levels. But at $270 a rear fitted i can get a pair of Stealths fitted for $10 more.
hth
cheers Brett
"Nan & Pop Racing"
Poppy Hops on .... CBR150 (Superlite) CBR954 "Blade"
Nanna Naps on .... MoriWAKI NSR85 (Motolite) ZX10R "Crim"
We may ride like Old Can'ts, But Phuk we look DOOG !!!!!!
User avatar
Nanna10r
Team Ninja
 
Posts: 4291
Joined: Wed Jul 14, 2004 10:42 pm
Location: Brisbane Australia
Bike: ZX10R
State: Queensland

Postby swabio-ACT » Fri Feb 10, 2006 2:36 am

hmmmm i just found out from a dude @ OCAU that there is a new tyre coming out.....the pilot power 2CT, 22% softer on the shoulders apparently..... might see how they go when they get here.......

Although I will prolly get a used set of PPR's to see how they go anyway :) IK has a spare set that he is keen to offload, he also only got around 2500km out of his rear (albeit on a slightly used tyre).
Image
User avatar
swabio-ACT
KSRC Contributor
KSRC Contributor
 
Posts: 1635
Joined: Sat Mar 26, 2005 9:52 pm
Location: Brisbane, Australia
Bike: ZRX
State: Queensland

Postby ZX-10R_04 » Sat Feb 11, 2006 9:42 am

swabio-ACT wrote:hmmmm i just found out from a dude @ OCAU that there is a new tyre coming out.....the pilot power 2CT, 22% softer on the shoulders apparently..... might see how they go when they get here.......

Although I will prolly get a used set of PPR's to see how they go anyway :) IK has a spare set that he is keen to offload, he also only got around 2500km out of his rear (albeit on a slightly used tyre).


yes thats it & i wanna give the new ones a go when this set wears out

http://www.michelin.co.uk/uk/front/affi ... ubrique=66

:wink:
If It Aint A Lime It Must Be A Lemon !!!!

04 ZX10R & 08 ZX10R
User avatar
ZX-10R_04
KSRC Regular
KSRC Regular
 
Posts: 762
Joined: Wed Aug 11, 2004 11:18 pm
Location: Launceston Tasmania
Bike: ZX10R
State: Tasmania

Postby Strika » Sat Feb 11, 2006 3:58 pm

I spoke to a mate who races SS yesterday, and he just tried a new set of Dunlop Qualifiers! Apparently awesome! Dunno if they are readily avail yet??? But may be worth considering! :) Oh...found the review!

Old name, new tire: Dunlop unveils its latest high-performance street radial
story by Lance Oliver
photos by Kevin Wing

How many times have you heard a race announcer say that a rider "threw on a set of qualifiers and set a new lap record."

Dunlop is counting on a lot of sportbike riders throwing on a set of new Qualifiers — with a capital Q — and setting their own personal bests, whether that's a quick lap at a track day or more confident riding on the street.

In racing lingo, qualifiers are short-lived, sticky tires good for a hot lap during a qualifying session. With that new connotation in mind, Dunlop pulled the old Qualifier trademark out of its archives and put it on its new street performance tire, which replaces the company's current D208 ZR. Dunlop says the D208 ZR remains the best-selling sportbike tire in the United States, despite its age in the marketplace. So a replacement tire is a big deal for the company.

With that in mind, Dunlop rented the Spring Mountain Motorsports Ranch at Pahrump, Nevada, and let the motorcycle press test the new Qualifiers back-to-back with the current D208 ZRs.

The D208 ZRs were good tires. But it only took a few laps to see what a big stride forward Dunlop has made with the Qualifier.

First of all, the changes. On the front, Dunlop made the Qualifier's profile more triangulated than the D208 ZR to make turn-in quicker. The front Qualifier's profile is virtually identical to that of Dunlop's track-day tire, the Sportmax D208 GP. At the rear, the Qualifier's profile is virtually the same as the D208 ZR's.

The D208 ZR's "cosecant wave" tread pattern is replaced by grooves that follow the direction of the force placed on the tire at various lean angles.

Dunlop's Mike Manning said a lot of research and development time went into seeking just the right compound for optimum sport performance. The Qualifier's blend of three polymers provides more grip and also warms up more quickly, Manning said. The Qualifier also is more compliant, and one result is a larger footprint at all lean angles (click here to see chart provided by Dunlop).

Finally, a rear Qualifier is about a pound lighter than a rear D208 ZR, which aids quicker acceleration and steering.

To show off these improvements, Dunlop borrowed some 600cc and 1,000cc sportbikes from the four major Japanese manufacturers to let us try their new tires.

So how do they work?

The difference between the Qualifiers and the D208 ZRs was immediately noticeable. The D208 ZRs were not a bad choice for a track day, but after a few laps, especially when the temperatures were warm, the rear would start to feel greasy. It was never a problem because the sliding was minimal and controlled. But I always knew I was losing a little grip.

With the Qualifiers, I could ride as hard as my skill allowed and the tires never exhibited any greasy feel. They just stuck.

As Dunlop promised, the front did make the bike turn in more quickly and although I'm no Superbike hero when it comes to late-braking maneuvers, other test riders with lots of racing experience on their resumes said the Qualifiers gave them considerably more confidence under hard braking. Credit that to the larger contact patch.


Sensors keep track of rear tire temperature in real time — just one of 18 channels on Dunlop's telemetry-equipped motorcycle.

Just the facts: Telemetry makes testing a bit more science, slightly less art
Tire companies have far more tools at their command today than ever before when it comes to designing a new tire. Dunlop engineers talked a lot about finite element analysis and finite element modeling when describing how they designed the Qualifier. These techniques allow the engineers to use computers to predict how a tire will perform even before it's built.

That means that Dunlop builds about half as many prototypes of a new tire for testing as it used to. Lower R&D costs help keep consumer prices from spiraling.

But eventually, prototypes must go onto the test tracks. That's when test riders such as Danny Roberts and Rich Conicelli provide all-important feedback.

Even the prototype testing has been computerized and made more objective, however. Dunlop uses a Suzuki GSXR1000 fitted with an 18-channel telemetry system to monitor exactly what's happening to the motorcycle and tires while the test riders are lapping.

Telemetry enabled Dunlop engineers to know not just that the Qualifiers were better than the D208 ZRs, but also where and why.

Test riders were pleasantly surprised when they saw that their best lap around Virginia International Raceway was a whopping 3.5 seconds faster than the best lap on the D208 ZRs. But telemetry showed that the big jump in performance was due to increased side grip. The GSXR with the Qualifiers mounted was anywhere from 3.5 mph to 8.3 mph faster through VIR's turns.

Test riders still have to do the riding. But now the riders — and the engineers who build the tires — have more data to help them understand exactly what's happening on the track.

Of course even two days at the track doesn't give any clue about how many street miles the Qualifiers will last or how they'll perform in the rain or in cool conditions. But on the second day of the test, when conditions were cloudy and cooler, the Qualifiers did seem to live up to their promise of warming up more quickly. That could be a real benefit on the street, where D208 ZRs can be slick on cool days.

The benefits for a day at the track are clear, however. If you're like me, with neither Superbike-level skills nor a slipper clutch, and you do a ham-handed job of matching engine rpm to speed while making a third-to-second downshift on a Yamaha R6, the rear end wiggles but never feels like it's going to get nasty with you. If, like me, you're a touch too abrupt on the throttle coming out of a turn on the Honda CBR1000RR and the rear starts to spin, the Qualifier minimizes the drama and maximizes the grip.

So that's my perspective — the point of view of a street rider of modest skills who gets on the track now and then.

Maybe you're a faster rider, focused mostly on track days, and you're looking for the impressions of someone with a higher skill level.

Well, you're not faster than Jason Pridmore. The AMA Superbike rider was on hand testing the Qualifiers, not because he's going to give up racing slicks for streetbike rubber, but because his Jason Pridmore Star School instructor bikes wear Dunlops. Currently, instructor bikes are shod with the D208 GPs, the track-day version, but that may change.

"I think these are better," Pridmore said after a long run on the Qualifiers. "Usually, I can get a new set of GPs to start spinning after six or seven laps. I was out there 20 laps and only the last few laps were they moving around. And it was nothing. It was easy to control."

While Dunlop's main goal was to replace the D208 ZR with a better street radial, Pridmore's comments may reveal another advantage offered by the new Qualifiers. Many advanced riders who do track days will switch between D208 GPs for track days and D208 ZRs for street use. It's a labor-intensive approach, but it maximizes both track and street performance with one bike.

The Qualifiers represent an attractive alternative for the rider who doesn't want to do that tire-changing routine. Mount a new set of Qualifiers for a track day, get performance equal to the old D208 GPs, and then leave them on and know you'll get street performance better than the D208 ZR street tires.

One final note. The Qualifiers we tested are the replacement tires that will be available at your dealer. Dunlop is also making other versions of the Qualifier to be used as original equipment on some 2006 sportbikes, and those tires may differ slightly due to specifications from the manufacturer.

The Dunlop plant is already producing Qualifiers and they should be available from your dealer or accessory store in January, 2006 in the following sizes:

Front:
Rear:
120/60ZR17
160/60R17
120/70ZR17
170/60R17
130/70ZR16
180/55ZR17

190/50ZR17

200/50ZR17
"I hate to advocate drugs, alcohol, violence or insanity to anyone, but they've always worked for me" Hunter S. Thompson.
There are really only two questions in life. 1.Which way do i go? 2.What is the lap record?
User avatar
Strika
VIP MEMBER
VIP MEMBER
 
Posts: 8373
Joined: Tue Feb 01, 2005 8:02 am
Location: Melbourne
Bike: Yamaha
State: Victoria


Return to General Tech & Performance Talk

Who is online

Users browsing this forum: No registered users and 5 guests