Kawasaki Sportsbike Riders Club - Australia - Online Forum

Anyone know of any powder coaters in the Sydney metro area?
Im trying to make something hideous look slightly better

We have a powder coating joint next to us,well a fencing mob that powder coat in miranda if that helps.I get on well with the powder coater..

Action Malek in Hiles St Alexandria.Wouldn't use them for high end stuff because most of the gear they do is wrought iron so they aren't delicate fuss pots but are good for run of the mil stuff.

Its to powder coat the frame on my zx9r tracky. Its a hideous red right now.
Im looking at matte black.

I think this joint does more of a satin black,i will get some pics tomorrow of a few things i had powder coated on my bike.PS the frame wont be a problem,but just to be sure i will ask them tomorrow.

MAXUMIS wrote:I think this joint does more of a satin black,i will get some pics tomorrow of a few things i had powder coated on my bike.PS the frame wont be a problem,but just to be sure i will ask them tomorrow.

Thankyou!

PM me if you get stuck

A mate of mine has a powdercoating line.

mostly decorative fencing, and does a good quality job
Cheers

let me know how you go im keen to do my rim gloss black.

Baddie wrote:let me know how you go im keen to do my rim gloss black.

Ive had the rims powder coated on my track bike. Lost count of how many times the tyre changer says " All care no responsability if I chip the edges "
(They are black which is lucky I just use an Artline pen as touchup)
I will consider polishing the edges next time.

Here is a couple of picks.



I forgot to ask today mate but i will write it down for tomorow!

PS im glad i don't make money from pic's

I did my 6r frame in a textured black, i'd be looking at charging around $160 for a frame and sub frame.



Edit. to add my factory is in brookvale.

I had a talk to them today and they can do it but they said around 150 its new owners now unfortunatly,back when Mat owned it ,it would have been a case of piss.PS i deleted one pick as i just found out it was a vid

MAXUMIS wrote:I had a talk to them today and they can do it but they said around 150 its new owners now unfortunatly,back when Mat owned it ,it would have been a case of piss.PS i deleted one pick as i just found out it was a vid

Ok. thanks. I better get stripping!

http://www.precisioncoating.com.au

These buys just did a job on a mates Z1; amazing finish and was pretty cheap too!