Kawasaki Sportsbike Riders Club - Australia - Online Forum

Ok, after getting some quotes for clutch kits, i have found 2 kits avaliable that suit my needs

1. EBC fibre plates and springs, 100 dollars pick up close to me

2. Goodridge plates and springs for 113 including delivery.

which would you suggest, i havent had any experience with either company so im not sure which to choose. i was heading towards EBC just because theyre near me and i can pay in person.

either one will do the job fine, they are probably both sourced from the same manufacturer anyway...

the correct answer is actually 'Barnett', not sure if they make a kit for your bike.

either have a good rep
although lots here tend towards the Goodridge...

either one will do the job fine, they are probably both sourced from the same manufacturer anyway...

the correct answer is actually 'Barnett', not sure if they make a kit for your bike.

Cool
_________________
"...You're blaspheming....I don't have to work with a blasphemer....."

ZX12R - WARNING - Heavy Fines - Loss of Licence

fark me Dave
where you spring from..???
whats with the ZX12r warning? someone been a bit norty?

cheers

Hi Ian

I will be in and out like a honeymoon dick over the next few months......been busy building bikes, got one to finish off in the next 4 weeks, wait till some photos of *that* baby hit the site

no speedin' fines recently, have been very quite. Knock on wood......

Gosling1 wrote:no speedin' fines recently, have been very quite. Knock on wood......

I didnt think anyone who rides a 12 gets speeding fines, its just when they get pulled over for routine licence checks, they see their age and tell them to go home and spend time with their great grandchildren and rip up their licence.... old bastards

barnett do make a clutch kit for my bike, but its alot more expensive, about 160 dollars compared to the 100 flat for an EBC

STC slipper from Italy... unfortuantely they dont make one for the 12