For general Technical and Performance Discussions
Sun May 20, 2012 1:26 pm
In recent days i've noticed a few seconds after coming to a complete stop (on the zed) the front lifts.
Not knowing that much bout front forks, i will have to take it in, but I wanted to know if anyone knew why?
Last edited by
Possum on Sun May 20, 2012 7:47 pm, edited 1 time in total.
Sun May 20, 2012 7:17 pm
is it when you take you foot off the rear brake?
if not then maby its sticktion (or how ever its spelt...)
has the oil and seals ever been done?
Mon May 21, 2012 12:51 am
They should lift but immediately not after two seconds. You compress the forks when you use the front brake to come to a stop and they should return immediately after the pressure is removed, (stopping with the front brake). It sounds like your rebound damping is either set way to tight or the rebound damp valve is partially plugged. At a stop bounce the front end and see if you can duplicate the problem, if you can loosen the rebound adjustment screw, (if it has one???) then try it again. It could also be a warped or dinged fork piston although not likely unless you have been in a wreck. If you have no rebound ajustment screw you might be looking at a fork overhaul. Some of you front end guru's might have more ideas. Good luck and let us know what you find.
Mon May 21, 2012 7:43 am
I reckon it's just sticktion.
Mon May 21, 2012 11:03 pm
Tried bouncing the front end and its intermittent.. worse when i brake the front end hard
Never stacked it/bingled it
Timmy the oil/seals have never been done on the zed
Had to look up this Stiction..
"Stiction (μs) is the static friction that needs to be overcome to enable relative motion of stationary objects in contact"
Hmm might be onto something there.. but why does this happen? just general wear and tear?
Mon May 21, 2012 11:32 pm
id get a front end lube job...
Tue May 22, 2012 6:24 am
Try owning a zx10.
Stiction is shocking...
Tue May 22, 2012 7:56 am
They are in the top drawer , right beside the knives
Tue May 22, 2012 8:07 am
You can induce a heap of stichion by tightening the front axle from just one side. Slack off the axle, bounce it around a bit, then tighten it again using a hex key on both ends and see if its better.
Wed May 23, 2012 5:23 pm
hoffy wrote:id get a front end lube job...
And one for the bike too while you're at it Poss
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.