Ignition Coils - does side matter

OK so the genuine Kawasaki Ignition coils are two different part numbers, one for the left side ie cylinders 1 and 4 and the right side cylinders 2 and 3. The left one is $170 and the right one $160

The left one is in stock and I can get it now, the right one (the one I think I need) has to come from Japan and will be three weeks. I'm going to replace both just for the fun of it (heaven knows what else would you do with a spare $170)

My question is....can anyone see why I can't temporarily take the new left one and stick it on the right side. The terminals will probably be arse about but I think I'm smart enough to get that right.

Any help would be mucho appreciado

If it has the same ignition timing, as in an even firing order, then it shouldn't matter I wouldn't think. The firing intervals would be the same for both coils wouldn't they?

It shouldn't damage anything to try...

That's what I was thinking mate......if I blow up the CDI I'll let you know the answer to your last statement

I have done it before glen, on the vfr400. Only difference was mounting lugs and the terminals, but they were coloured so couldn't stuff that up, cable tie sorted out the mounting

Thanks mate. I'll give it a shot. If you see a mushroom cloud spreading over kellyville you'll know I fucked it up.

No mushroom cloud yet...

No mushroom cloud yet...

Don't worry dude if I go you go with me.

No mushroom cloud yet...

Don't worry dude if I go you go with me.

If u could avoid a major disaster tonight or tomorrow night Id appreciate it

No mushroom cloud yet...

Don't worry dude if I go you go with me.

If u could avoid a major disaster tonight or tomorrow night Id appreciate it

You on a promise Rob

Not on overtime. I hate disasters on standard pay

they've got different length plug wires

That's correct, but assuming I can get leads 1 and 4 to reach cylinders 2 and 3 will it work ?

just buy one coil & use the plug wires off the old one if you have to...should be fine

just buy one coil & use the plug wires off the old one if you have to...should be fine

Yep that's what I was thinking.

Cheers

Glen, I think I hinted at checking, but have you checked the ignition barrel and the kill switch to make sure they are not intermittently breaking contact? I'd hate for you to spend all this cash to find it's a dirty kill switch or a faulty ignition barrel or wiring!