ZX10R PCV custom mapping
Thu Oct 28, 2010 8:38 pm
On Monday I took the bike down to Trevor at Doin Bikes in Chipping Norton to get my PCV custom mapped.
A few people were interested in the results so here they are below.
Performance mods installed prior to mapping:
Healtech XTRE. (still can't tell if it even does anything)
Ivan's Performance block off plates.
Akrapovice carbon hexagonal slip on + link pipe.
1/5 throttle insert.
Power vs RPM
Power vs Time
The charts don't show much of a difference especially in Power vs Time, but the butt dyno tends to differ as these charts only show full throttle performance.
The bike tends to rev quicker, has more instantaneous pickup, delivers the power a lot smoother and feels like it has quite a bit more poke mid range.
I have not played with the software, so does anybody know how to get the map off the PCV, and does the software that comes with it allow me to take open up the mapping and take a screen dump of the fuel mapping?
A few people were interested in the results so here they are below.
Performance mods installed prior to mapping:
Healtech XTRE. (still can't tell if it even does anything)
Ivan's Performance block off plates.
Akrapovice carbon hexagonal slip on + link pipe.
1/5 throttle insert.
Power vs RPM
Power vs Time
The charts don't show much of a difference especially in Power vs Time, but the butt dyno tends to differ as these charts only show full throttle performance.
The bike tends to rev quicker, has more instantaneous pickup, delivers the power a lot smoother and feels like it has quite a bit more poke mid range.
I have not played with the software, so does anybody know how to get the map off the PCV, and does the software that comes with it allow me to take open up the mapping and take a screen dump of the fuel mapping?