Building your own motorbike work bench?

Does anyone have the plans available that they are willing to share on how to build your own hydraulic or pneumatic operated work bench??

I want to build my own, unless it's cheaper and easier to buy one.

Can anyone help me out?

Thanks.

Attachments

500s_280.jpg (17.25 KiB) Viewed 2015 times

firstly, how are your welding skills?

arc welding.. poor (could do it to save my self that's about it)

mig (which I own - gasless) not too bad. I can get a good bead.

I figured there would be lost of cutting, welding, grinding and painting.

http://www.chansen.net/Members/VMAX/Mot ... 132006.pdf

How often would it get used ?

The following idea from another forum I frequent was to put the bike up on Front & Rear stands and build one slightly below it

Picture029.jpg (61.81 KiB) Viewed 1868 times

A closer look at a good idea

Picture034.jpg (51.14 KiB) Viewed 1864 times

.... it's cheaper and easier to buy one......

there is your answer right there mate

thanks Gos... thought it might be...

The Molnar single phase belly lift works very well but that's just showing off I guess