1996 zx-7r rear bake light switch and mystery box

hi everyone, i was looking over my bike which i've had for about 2 years now and i noticed a box that i've never seen before. it has 2 grey buttons on the side of it. it is mounted to the frame under the seat. I'm not very mechanical......is it a alarm or a aftermarket part. can anyone shed light on this? the picture is below. Also i was wondering the best solution for a rear brake light switch that sticks.

IMGP2373mod.JPG

quite obviously a powercommander dude,

the previous owner has probably had it fitted...

you know the special powercommanders for carbies?

as a side note,

i have no idea what it is...

as a side note,

i have no idea what it is...

+1 deffinately don't think its a stock bit. you might have to follow the wires and find out what its attached to. that should give you a hint.

POWER COMMANDER IS A GOOD GUESS....HOPEFULLY SOMEONE GIVES ME SOME INPUT. IT HAS 2 BUTTONS TO ADJUST SOMETHING. I'M TO SCARED TO TRY THEM...MIGHT BE A SELF DESTRUCT

Wattie was being a smartarse, power commanders only work on efi bikes, which yours is not.

if it was close to the engine bay then i would hazard a guess that it could be a high energy spark kit. If it was towards the tail, wellll then im not so sure, but it'd be a silly place to put a high energy kit unless there wasn't an alternate place to mount it.

MIGHT BE A SELF DESTRUCT

+1 for self destruct button hahaha

If it has wiring where does it go.......... my guess would be alarm

Was the previous owner Middle Eastern?

I had a shitty old mazda 626 years ago that had a redback alarm fitted to it. The funny thing was it kept going off and the owner got the royal shits with it, so he had it totally bypassed and until the day i got rid of it, the alarm sat there and never did a damned thing.

Looks like an early Vortec style adjusatable ignition curve module.
Cut the cable ties and have a look for any labelling / ID

And Bloody well hurry up.
The suspense is killing me

BOOM...?

Looks like the image url changes...I'll re-post when I get home.

Ok, home and not busy:



If it's Part Number 21119 in the bottom RH corner of the diagram then it's a:

21119 21119-1460 IGNITER

HTH, Mick

Bump