Kawasaki Sportsbike Riders Club - Australia - Online Forum

So the bits and pieces my mate has been doing to my bike are almost complete, only need to source a rear seat cowl, but very happy with the results so far!!

Heres how she started:



And here she is 99% complete!!


And some naughty lights.....

duf duf duf duf duf duf duf duf duf duf duf duf ching
That pipe needs to be halved in length

robracer wrote:duf duf duf duf duf duf duf duf duf duf duf duf ching
That pipe needs to be halved in length

+1
Although I'm not a huge fan if really short cans, that one needs at least a bit lobbed off.

Other than that - its a very fine 9!

noice

i must say, the lights look quite good on it, not too over the top like some ive seen. nice ride mate

Nice mate, Goes to show there really can't be too much Kawasaki Green in the world.

Nice! I'm with everyone else in regards to the can being shorter. i'd like to see a clear pic with just the leds on though.

About there:



I'm thinkin'

JUST the leds on. its hard to see what exactly is lit by the leds on the rear end and whats lit by the other source from the left of the pic!!

Here is a shot just LED's, i requested subtle and i think he nailed it! Also how would i shorten the pipe? Is it a new exhaust? If so no go as the stimulus is all spent......

Hrmmm i been thinking of doing somethign similar with the LED's, but orange, on my Zed, how much did it all set you back, and is it run off a speerate switch?

The 9 looks sweet colourcoded and the weheels loogk great! but agree with everyone else about trimming the pipe! again a mod im about to do to my Zed

I actually traded my old 83 VT500e for the work, so technically it cost me nothing, and the lights work off a seperate switch but are hooked up through the headlights so as not to drain the battery if left on....