Kawasaki Sportsbike Riders Club - Australia - Online Forum

Well its finally done........ The front end project is finished ... now for that rear end!
The first ride today was ....WOW what a difference, she just soaks up the bumps compared to the dreded Z pogo... & the radial brakes are fantastic after spending considerable time with the bike on the bench waiting for the axel to be machiened I had plenty of time to extracate every single air bubble from the brake system... running motul race spec fluid she stops on a dime..... cant wait till the pads bed in they will be even better

For more info: http://www.ksrc-au.com/phpBB2/viewtopic.php?t=13994

mmmaaaaaaaatttttttttttteeeeeeeeeeeee!!

That look Fcuking Cool!!

Well bloody done Rob

Oooooh, check out those calipers! Makes the stock ones look kinda poxy.

your a bastard!!!!

looks great........when are you doing it wattie

Looks awesome Rob...

Great work

Phil wrote:looks great........when are you doing it wattie

i'd probably do the ZX6 or ZX10 conersion mate...

take my bike to a shop, and pick up a zx6 or zx10....

suspension problems sorted, and more ground clearance...

Wattie wrote:

Phil wrote:looks great........when are you doing it wattie

i'd probably do the ZX6 or ZX10 conersion mate...

take my bike to a shop, and pick up a zx6 or zx10....

suspension problems sorted, and more ground clearance...

mmm clearance is a problem...You still cant go crim on us!

With my conversion I looked at the cost of the 07 Zed 750 a few grand after trade in & the cost of the conversion ...bout $1200 all up + the fact that the USD forks on the 07 zed are bottom of the barrel (gixxer 1000 USD forks are right up there) I think at the end of the day the conversion is a good investment
This is a bike I want to keep..... + the 07 Zed looks...well not my cuppa.

that looks good mate..how kwaka shoulda made em!!

It came up a treat Rob .Did you have to muck around with the gixxer fork internals or was it pretty much spot on as is?????

that is sexy..

mmmmm very nice.

Neka79 wrote:that looks good mate..how kwaka shoulda made em!!

What, with Suzuki parts??

Rob - that looks fantastic mate, well done. Is there room on the trailer to bring it to the BSM ??

rocketrod wrote:It came up a treat Rob .Did you have to muck around with the gixxer fork internals or was it pretty much spot on as is?????

Left all the same except for fresh fork oil... will see how it goes before doing anything else. .... dave & I were talking about it the other day & without looking it up the weight should be about the same? but at the mement I am going to enjoy & make changes later.